Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Wellborn Roofing: The Houston Owner’s Guide
We stock and install Wellborn-compatible roofing parts and gutter systems across Houston, with typical installed costs running $400 – $1,800 for repairs and $8,000 – $20,000 for full roof replacements. Most Houston homeowners discover a Wellborn roofing failure the same way: a water stain spreading across the ceiling after a hard rain, or granules collecting in the gutter after a summer storm. You’re not looking for guesses here, and we don’t trade in those.
At Bradford Remodeling Co Houston, we carry the Wellborn roofing components that actually fail in this climate: flashing, valley metal, ridge caps, drip edge, and the fastener systems Houston humidity and storm cycles chew through first. Our crews run background-checked and uniformed, and every job gets a written price before any work starts. That’s not a courtesy, it’s how we operate.
One thing up front: Bradford Remodeling Co Houston is an independent service provider. We’re not affiliated with Wellborn directly, but we work with their roofing spec sheets and install to manufacturer tolerances, so your warranty paperwork stays clean.
Which Wellborn Models This Applies To
Wellborn roofing components are typically spec’d as part of whole-home exterior packages, so compatibility depends on the original build sheet and the roofline geometry rather than a single model number. We work with the full Wellborn roofing line: asphalt shingle systems, metal panel profiles, and the flashing and edge details that go with each.
The compatibility gotcha in Houston is the drip edge. Wellborn specs a minimum 24-gauge galvanized drip edge, but a lot of retrofit jobs ended up with thinner builder-grade material that buckles under thermal expansion. We see it on homes from Katy to Pearland. If you’re replacing one section, measure the exposed flange width before buying anything. Wellborn systems run a 1½-inch and a 2-inch flange depending on fascia board thickness, and mixing them creates a lip that catches water.
For the part itself, ask this question first: OEM or aftermarket? Wellborn OEM parts come with the manufacturer’s spec sheet and preserve any remaining system warranty. Quality aftermarket equivalents from GAF, CertainTeed, or Owens Corning often match or exceed the original at a lower price point, and we install those regularly. The right call depends on how much roof life is left. If the decking is sound and you’ll be in the home another five years, OEM keeps everything traceable. If you’re squeezing two more seasons out of an aging roof, a spec-matched aftermarket part does the job without overpaying.
Styles & brands we work with
Signs Your Wellborn Roofing Is Failing
- Water stains on ceilings or walls after a storm. This is the number one call we get in Houston. A Wellborn roof that’s been through ten years of Gulf Coast weather usually fails at a flashing seam first: chimney, vent pipe, or valley. The shingles themselves might still look fine.
- Granules in the gutter or at downspout exits. Asphalt shingles shed granules throughout their life, but a sudden accumulation of granules after a hailstorm or wind event means the protective layer is gone and the shingle is cooking in the Houston sun. Once that happens, cracking follows within a season.
- Lifted or curled shingle edges. Houston’s humidity cycle (wet summers, dry winters, then wet again) causes decking and shingles to expand and contract at different rates. If you see shingles curling at the edges, the nail seals have broken and the roof is now wind-vulnerable.
- Rust streaks on metal flashing or drip edge. In Houston, the salt air from the Gulf and the chemical runoff from a thousand AC units above the roof line eat galvanized metal faster than in most inland cities. Once the zinc layer is gone, the steel underneath fails quickly.
- Interior musty smell in the attic. Not every roof failure announces itself with a drip. Sometimes it’s a slow seep at a pipe boot that keeps attic insulation damp for months. By the time you smell it, the decking underneath is already soft.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
In Houston, a Wellborn roof repair runs $400 – $1,800 depending on what failed and how much material has to come off. A full Wellborn roof replacement on a typical suburban home runs $8,000 – $20,000, pushed higher or lower by square footage, roof pitch, decking condition, and whether you’re keeping the existing flashing system or upgrading it.
Here’s the breakdown:
- Flashing repair (vent pipe, chimney, or valley): $400 – $900 installed
- Drip edge replacement (per side of home): $250 – $600 installed
- Ridge cap replacement: $350 – $800 installed
- Shingle replacement (isolated section, 10×10 area or smaller): $350 – $1,200 installed
- Full roof replacement (asphalt shingle, existing decking): $8,000 – $18,000 installed
- Full roof replacement (with decking replacement needed): $12,000 – $20,000 installed
Every line includes the part, the labor, the fasteners, the sealant, and the disposal of old material. No separate trip charge, no disposal fee hiding in the fine print. You get the written price before we load a single tool, and that number doesn’t move at the door. The 365-Day Done Right Promise covers the work in writing: if the repair or replacement fails within a full year, Bradford Remodeling Co Houston returns and corrects it at no charge. That’s the guarantee, stated plainly.
DIY or Call Us?
Some things are safe to check yourself. Walk the perimeter after a storm and look for shingle tabs in the yard. Check the attic for daylight at the ridge line. Clear debris from the valleys and downspout inlets. Those steps take an hour and they tell you whether you even need to call.
But the actual roof work is not a weekend project. Working on a Houston roof means a pitch of 6/12 or steeper in most subdivisions, heat indexes over 100 degrees for half the year, and nails that have been baking in the decking since the Bush administration. One wrong step on a shingle roof is a fall. One wrong flashing bend is a leak that costs more than the original repair. If the part involves anything beyond visual inspection, call us. Curtis Lane has been running crews in the Houston market for over a decade, and he’d tell you the same thing: a roofer’s insurance premium exists for a reason. Call (940) 289-7658 and we’ll get you a written number, not a story.
FAQs
A properly installed Wellborn asphalt shingle roof lasts 18 – 25 years in the Houston climate, but that span depends on the decking, ventilation, and the quality of the flashing. Storm damage shortens it. Poor attic ventilation shortens it faster. If the decking breathes and the flashing is right, 20 years is a reasonable expectation.
Yes, if the failure is isolated to flashing, a fastener issue, or a single shingle section. If the decking is soft, the granule loss is widespread, or the shingles are curling across entire slopes, a repair becomes a temporary patch. We’ll tell you which one you have. Call (940) 289-7658 for an honest assessment and a written estimate.
A flashing or shingle repair is usually completed in one day, including cleanup and a walkthrough of the written scope. A full roof replacement runs two to five days depending on decking condition and weather. Houston storms don’t follow our schedule, so we build in dry-day buffers before we commit to a date.
We keep the common Wellborn-spec parts on the truck: drip edge in both flange widths, ridge cap in the standard profiles, pipe boots, valley metal, and sealant. Special-order parts, like unusual flashing profiles or metal panel matching, take three to seven days from our distributor. If it’s a same-week need, call (940) 289-7658 and we’ll check current stock and lead times before you commit to anything.
Straight scope, straight number, that’s the whole conversation. If you need a Wellborn roofing part matched, priced, and installed by a crew that puts it all in writing, call Bradford Remodeling Co Houston at (940) 289-7658 for a free estimate.
Written by Curtis Lane, Owner, Bradford Remodeling Co Houston at Bradford Remodeling Co Houston, serving Houston and nearby areas.
